Lothar the Black
ALL MINIATURES ARE:
32mm models printed at 14k resolution / .02 layer height.
75mm models printed at 7k resolution / .04 layer height.
Printed in gray ABS like resin for stronger prints.
Solid. (Hollowed at 2mm thickness if needed.)
Supported properly to prevent any damage to model when supports are removed.
Printed in one piece or fewest pieces possible.
Washed in 99% IPA, followed by a wash with an ultrasonic cleaner for crisp, clean prints.
Cured with UV curing machines.
Thoroughly packaged to prevent damage during shipping.
ALL MINIATURES ARE:
32mm models printed at 14k resolution / .02 layer height.
75mm models printed at 7k resolution / .04 layer height.
Printed in gray ABS like resin for stronger prints.
Solid. (Hollowed at 2mm thickness if needed.)
Supported properly to prevent any damage to model when supports are removed.
Printed in one piece or fewest pieces possible.
Washed in 99% IPA, followed by a wash with an ultrasonic cleaner for crisp, clean prints.
Cured with UV curing machines.
Thoroughly packaged to prevent damage during shipping.
ALL MINIATURES ARE:
32mm models printed at 14k resolution / .02 layer height.
75mm models printed at 7k resolution / .04 layer height.
Printed in gray ABS like resin for stronger prints.
Solid. (Hollowed at 2mm thickness if needed.)
Supported properly to prevent any damage to model when supports are removed.
Printed in one piece or fewest pieces possible.
Washed in 99% IPA, followed by a wash with an ultrasonic cleaner for crisp, clean prints.
Cured with UV curing machines.
Thoroughly packaged to prevent damage during shipping.
PLEASE NOTE - Uncured resin is toxic! Even when properly and thoroughly cleaned, pockets of resin may still be trapped inside the model and may leak out during shipping. If this is the case, STOP WHAT YOU’RE DOING and wash your hands with soap and warm water. Clean the model and any contaminated area with IPA (rubbing alcohol.) Once cleaned, place the model outside in direct sun light to allow any left over resin to fully cure. Make sure to not leave the model in direct sunlight for too long. This could cause the print to become brittle and easily break.
